Sikaflex-116 High Grab - Construction Adhesive - Sika

Sikaflex-116 High Grab - Construction Adhesive - Sika

Sikaflex-116 High Grab is a high initial tack construction adhesive that bonds most building material substrates.

Features

• High initial tack.
• Fixing heavy objects without temporary fixing.
• Good applicability.
• Very low VOC emissions.
• Sealant-adhesive with CE marking.

Application areas

An adhesive for bonding construction elements and materials such as:

• Concrete.
• Masonry.
• Most stones.
• Ceramic.
• Drink.
• Metals.
• Glass.
• Mirrors.

For indoor and outdoor use.

Application

1. After the necessary preparation of the medium, prepare the end of the cartridge before or after inserting it into the gun, then attach the nozzle.
2. Apply in beads, strips or dots a few centimeters apart.
3. Use only manual pressure to position the elements to be glued and this before a skin forms on the glue.
   A badly positioned element can be easily peeled off and then repositioned during the first minutes following application.
4. If necessary, temporarily use tape, shims, or supports to hold the assembled components together during the onset of the cure time.
5. Fresh, uncured adhesive remaining on the surface should be removed immediately.
   Final strength will be achieved after Sikaflex- 116 High Grab has fully cured, ie. after 24 to 48 hours, at 23°C, depending on environmental conditions and adhesive layer thickness.

Consumption

* Note: For heavy objects or thicker cords, consumption may increase (up to ~120 ml per linear meter).
These figures are theoretical and do not take into account any additional material due to surface porosity, surface profile, level variations or wastage, etc.

Conditioning

• 290ml cartridge.