SikaGard-790 All-In-One Protect - Oil and graffiti repellent - Sika

SikaGard-790 All-In-One Protect - Oil and graffiti repellent - Sika

Sikagard-790 All-in-One Protect is a protective impregnation that is developed to protect all types of porous mineral surfaces against the penetration of liquids with aqueous bases and oils, and to prevent or significantly reduce stains on these materials.
It does not form a film on the surface and therefore remains completely invisible.

The Sikagard-790 All-in-One Protect allows the diffusion of water vapor in all directions, which allows the treated constructions to keep their normal hydrothermal and hygric behavior.
It makes graffiti removal easier on treated surfaces (with appropriate cleaning products).

Features

• Protection against water and oil penetration
• Stain protection
• Suitable for all types of facades, floors and roofs
• Suitable for use on most building materials
• Offers invisible protection, does not change the appearance
• Allows the support to breathe
• UV light resistant
• Reduces the problem of graffiti, as it facilitates removal
• Eco-friendly - low VOC's

Application areas :

Sikagard-790 All-in-One Protect can be used to protect facades, floors and roofs all made of mineral materials commonly used in construction such as:

• Natural stone such as granite, limestone, marble, etc. and also artificial or reconstituted stone
• Terracotta tiles, clay/cement based, roof tiles
• Concrete and cementitious plaster/plaster, etc.

Application

1. The Sikagard-790 All-in-One Protect is delivered "ready-to-use", but you must always shake the sealed cans well before opening and use.
2. Do not dilute the product and apply directly to the surface until saturation with a brush, roller or low pressure spray.
3. This is normally done in 2 coats using the wet in wet technique.
4. Do not use too much, roller and spread the excess product before letting it dry.

Appearance

• Colorless liquid which may have a slight yellowish color and a slight haze.
• Transparent after drying.

Consumption

Consumption will depend on the type and porosity of the support:

• Typically on very porous substrates, 300 to 600 gsm/coat
• Typically on low porous substrates, 50 to 200 gsm/coat

Conditioning

5L and 20L