Professional Rubberized Coating - Spray Rubber - Zep Industries

Professional Rubberized Coating - Spray Rubber - Zep Industries

High-quality black rubber . Protects with a rubbery layer for years against corrosion, stone chips, and wear .
Also ideal for absorbing vibrations .

Properties :

• It does not crack or harden.
• Thick coating. Provides excellent coverage with a single coat on surfaces. Excellent adhesion, no primer required.
• Dries quickly, allowing the product to work immediately.
• The flexible layer can be sprayed.
• Apply several thin coats and allow to dry between coats for best results.
• Provides a protective barrier against rust-causing elements such as water and salts.
• Once applied, it protects surfaces from corrosion.

Applications:

• Specifically designed as an alternative to underbody coatings and crushed stone, which require application with an air gun. Different textures can be achieved depending on the thickness and spray distance during application.
• Ideal for restoring a variety of OEM finishes, as well as for applying and restoring the lightweight crushed stone coating on the underside of sills and front panels.
• Due to its excellent adhesion, it is also suitable as a sealant and protective layer for welded repairs. It is resistant to harsh conditions such as wheel arches and underbody areas.
• Protects the vehicle's metal from wear and corrosion while reducing unwanted noise caused by excessive vibration.
• Can also be used on air conditioners, pipes, metal sinks, downpipes, eaves, fence posts, etc.

Instructions for use:

1. Remove rust, dirt, oil and other contaminants.
2. The surface must be clean and dry.
3. Shake well until the ball of mixture detaches.
4. Shake for 1 minute.
5. Repeat the stirring process every minute during spraying.
6. Hold the aerosol can at a distance of 20 to 30 cm and spray a light coat with a smooth motion.
7. Build the coating in several thin layers.
8. Allow the previous layer to evaporate before applying a new layer.
9. Clean the valve after spraying by turning the can upside down and spraying for 5 seconds until the valve is clear.
10. Allow the product to dry completely (minimum 2-3 hours, preferably overnight) before re-varnishing.

Packaging:

600 ml aerosol.

FAQ - Frequently Asked Questions

1. Can this coating be used under a car?
   Yes, it is perfectly suited for wheel arches, chassis and underbody, offering corrosion and vibration protection.
2. Is it really waterproof?
   Yes, once dry, it forms a waterproof barrier against water, moisture, splashes and de-icing salt.
3. Can it be used on plastic?
   Yes, but it's most effective on rigid plastics. It's recommended to test a small area before full application.
4. Can you paint over it?
   Generally, it is not intended to be painted. Some paints may adhere, but a preliminary test is essential.
5. How long does it take to dry?
   Touch dry: 10 to 20 minutes. Fully dry: 24 hours.
6. Is the product resistant to cold?
   Yes, the formula remains flexible and does not crack, even at low temperatures.
7. How many square meters can be covered with one can?
   On average, 1 to 1.5 m² depending on the thickness of the layers.
8. Can it be used to seal a leak?
   It can offer a temporary solution for small leaks, but does not replace a structural repair.