Vlekstop W - Special impregnation for brick, stone and concrete - Lithofin

Vlekstop W - Special impregnation for brick, stone and concrete - Lithofin

Lithofin Vlekstop W = Lithofin Fleckstop W

This special product is a water-soluble impregnating agent. It is solvent-free, ready to use, and contains highly effective polymers and special additives that significantly prevent oil and water penetration.

It penetrates absorbent, porous surfaces and immediately creates a very thin and invisible film in the capillaries.

This reduces absorption and significantly prevents the penetration of oil and grease that can cause stains.

The dirt therefore remains on the surface from which it can easily be wiped away. The appearance of the treated surface changes little or not at all.

Technical specifications:

• Density: approx. 1.0 g/cm3
• pH: approx. 4.5
• Appearance: clear, yellowish
• Odor: almost odorless

Scope of application:

This product can be used both indoors and outdoors for protective treatment for easy maintenance, stain resistant in stain-sensitive areas such as kitchens and dining areas, as well as for tables, worktops and the like.

The surfaces can be polished, smoothed finely or roughened.

Note: For polished surfaces sensitive to acids (marble, etc.) and on fine porcelain stoneware, the product's compatibility should always be tested beforehand. This is also recommended for all surfaces previously treated with other products.

Yield :

• Absorbent surfaces, e.g. stoneware: approx. 7 m²/L
• Raw concrete slabs: approx. 10 m²/L
• Polished natural stones: up to 20 m²/L

Vlekstop W - Special water-soluble impregnation - Lithofin

FAQ - Frequently Asked Questions

1. Is the product invisible after application?
   Yes, Vlekstop W is completely invisible and does not change the color of the material. It does not create a film.
2. Can it be used on a patio or a driveway?
   Yes, but wait 24 to 48 hours before walking or driving on it for optimal protection.
3. Does the product prevent moss and algae?
   The treatment significantly reduces absorbed moisture, thus limiting their appearance. For optimal results, prior cleaning is recommended.
4. Can the product be applied to a surface that has already been treated?
   Yes, if the surface remains absorbent. If water beads on the surface, stripping may be necessary.
5. What is the action time?
   Dry to the touch, 2 to 4 hours. Full protection, 24 to 48 hours. 7.
6. How often should the treatment be repeated?
   Generally, every 3 to 5 years, depending on exposure to sun, traffic and rain.
7. How can I check if the treatment is still effective?
   Apply a few drops of water. If they bead up, the protection is active. If they soak in, it's time to reapply.
8. Can it be stained or painted over?
   No, Vlekstop W partially blocks absorption and paints may not adhere properly.