ProtectGuard MG - Oil and water repellent for marble and granite - Guard Industrie

ProtectGuard MG - Oil and water repellent for marble and granite - Guard Industrie

ProtectGuard MG is a next generation protection product designed to protect low and very low porosity substrates.
It has a very effective ability to resist the penetration of water , oils , greases , weak acids (fruit juice, ketchup, etc.) as well as all types of dirt.

Advantages

• High performance protection against water, oil and stains
• Resists abrasion
• Permanent anti-graffiti property
• Does not form a film, lets the support breathe
• Invisible: does not change color
• UV and frost resistant
• Delays aging and facilitates maintenance

Use

• Low and very low porous materials: marble, granite, sandstone, slate, polished and crystallized materials, concrete, etc.
• Floors and facades
• New or old
• Inside and outside
• Recommended for terraces, pedestrian areas, living rooms, facades, stairs, etc.

Implementation

Substrate preparation

1. Apply the product to a clean, dust-free, degreased and dry surface.
2. Rinse thoroughly until the surface is free of all traces of cleaner.
3. Wait until the surface is completely dry before application.

Application

1. Use the product in its pure state: do not dilute.
2. Shake the packaging well before use and carry out a preliminary test.
3. Apply the product in one pass. Allow the product to penetrate and dry (10 to 60 minutes depending on the porosity and temperature of the material).
4. Do not overload the support, remove any excess with a clean cloth by dabbing the support before the product dries.
5. Surface dries in 1 hour.
6. The surface must be protected for 24 hours from traffic and liquids (rain, grease, etc.).
7. On very low porous or polished materials, the surface must be polished with a microfiber cloth after application of the treatment.
8. Optimal product effectiveness obtained after 48 hours of drying.

Application tools

Apply with a cloth brush or microfiber flat broom.

Consumption

8 to 20 m²/L.

Conditioning

Consumption depends on the porosity of the material.
0.5 L and 5 L.

Formerly: ProtectGuard MG Pro - Oil-repellent water repellent for marble and granite - Guard Industrie