Anti-stain Nano with beading effect - Akemi

Anti-stain Nano with beading effect - Akemi

Strong impregnation product to prevent the penetration of water , grease or oil .

Protects floors , tables and worktops made of natural stone and artificial stone (marble, Solnhofen stone, sandstone, earthenware), indoors and outdoors.

Starts to work within minutes of application and reaches full effectiveness after 2 or 3 hours.
Contains special substances that prevent liquid drops from spreading.

Features :

• Very fast protection
• Pronounced pearling effect
• No or only slight darkening of the color
• A very good repellent effect against oils and greases
• Very low absorption of water and dirt under the influence of humidity
• Rapid moisture removal in dry periods
• A very strong reduction in the adhesion of paints on treated surfaces, with an anti-graffiti effect
• Retention of the stone's ability to breathe, no film on the surface
• Does not stick during curing
• Does not yellow
• UV stability
• No methanol release during curing
• Emission class A+ (confirmed by an external research center)
• Food approved (approved by an external German research center)
• Reaction of effectiveness (20°C): 10-20 minutes
• Coverage: approx. 5 to 20 m²/litre depending on the absorbency and nature of the surface.

Use :

1. Shake well before use.
   The optimal conditions for impregnation are: the driest possible stone, a temperature between 10 and 30°C and protection from rain for 2 to 3 hours.
   During treatment, the coating must not be heated by sunlight or underfloor heating.
2. Cracks larger than 0.3 mm must be closed before treatment, anti-stain.
3. Generally, 1 to 2 applications without waiting for the first coat to dry are sufficient.
   On a weakly absorbent surface, dilution with AKEMI Nitro Diluent is recommended.
4. Apply the product with a brush or a wet broom.
   On facades, you can use a vacuum sprayer with low pressure (max 1 bar) and a nozzle distance of 5 to 10 cm (precaution: check the resistance and tightness of the hose to solvents).
   Apply the stain remover until it runs over 40 to 50 cm.
5. About 20 minutes after application, before the water repellent dries on the surface, wipe off any excess that is not absorbed with a cloth so that no product remains on the surface.
   To avoid streaks on polished surfaces, they must be repolished (using either a pad, a very soft cloth, or a sheepskin).
6. In case of reduced effectiveness or irregular application, it is possible to repeat the application without any problem.
   The effect of water and oil appears after a few minutes and full effectiveness is achieved after 2 to 3 hours.
7. It is necessary to ventilate well (approx. 2 - 3 days) when used in the food sector.
8. Cleaning of work tools can be done with AKEMI Nitro Diluent.

Packaging:

• 250 ml
• 1 L
• 5 L