Owaphos - Rust remover for metals - Owatrol

Owaphos - Rust remover for metals - Owatrol

Phosphating rust remover for ferrous and non-ferrous metals .

Properties :

Dual action:

Rock and phosphate → passive support:

• Real chemical sanding that modifies the surface of the metal: a chemical reaction creates a thin layer of metal oxide on the support to provide:
• Optimum adhesion of the finish on smooth supports such as galvanized, aluminum but also steel.
• Improved corrosion resistance of painted metals.
• Ease in the preparation of supports: avoids tedious mechanical sanding

Rust Destroyer:

• Eliminates rust from ferrous metals (and drips), white rust on galvanized steel, but also oxidation on non-ferrous metals (aluminum, zinc, galva...).
• Wetting properties (easy spreading) which make it easier to disintegrate rust and limescale.
• Restores shine to chrome substrates altered by limestone.
• The yield may vary and/or be lower depending on the condition and porosity of the support: 10 to 12 m2 /L per coat.

Application :

Phosphate or pickle:

1. Use pure.
2. Apply Owaphos.
3. Leave to act for at least 30 minutes.
4. Rinse thoroughly without rubbing (so as not to remove the passivation layer).

Remove rust:

1. To dilute: 1 to 3 volumes of water for light rust.
2. 1 to 1 part water for generalized rust.
3. Apply the solution to the dry support.
4. Leave to act between 15 and 30 minutes depending on the ambient conditions.
5. If necessary repeat the operation.
6. Once the result is obtained, rinse well then leave to dry without rubbing.

After phosphating, pickling, removal of rust on metals:

1. Apply the PID 60 type anti-corrosion primer as soon as it is completely dry without however exceeding 8 hours to avoid any resumption of corrosion.
2. On stainless steel or other non-ferrous metals that you do not want to repaint, apply Polytrol to avoid pitting corrosion and make the surface shine.

Destination :

• Exterior and interior (requires rinsing with water).
• Ferrous metals: steel, cast iron...
• Non-ferrous metals: copper, aluminium, zinc, chrome but also alloys (bronze, brass...).

Conditioning :

1L and 5L.