Sikafloor-4020 FiberLevel - Hybrid leveling compound EC 1 PLUS - Sika

Sikafloor-4020 FiberLevel - Hybrid leveling compound EC 1 PLUS - Sika

Sikafloor-4020 FiberLevel is a fast-setting, fibre -reinforced, gypsum-cement levelling mortar for floors .

The product combines the advantages of calcium sulfate (gypsum) and cement with the addition of fibers.
This helps reduce shrinkage and achieve rapid drying, which is ideal for subsequent application of floor coverings.
EC 1 PLUS label: very low VOC emissions .

Features

• Thickness 3-20 mm
• Quick setting for rapid completion of floor covering
• Ready for foot traffic after about 2 hours
• Suitable for underfloor heating systems
• Self-leveling
• Pumpable
• EC 1 PLUS label: very low VOC emissions .
• Very low stress/stress on the support
• Suitable for office chair castors in accordance with EN 12529

Areas of application

For equalization and leveling of interior substrates before application of:

• Textile floor coverings
• Resilient floor coverings (linoleum, vinyl)
• Reactive resin floor coverings
• Wooden floors
• Tile and natural stone floor coverings

Application

1. Add a maximum of 4.4 litres of water to a 20 kg bag.
2. Use a single or double-blade electric mixer (<600 rpm) with a spiral/helical blade for mixing.
3. Pour 4.2 to 4.4 liters of clean water into a clean mixing container.
4. Mix slowly, gradually adding the entire bag of powder to the water.
5. Mix continuously for 2 minutes to obtain a smooth, uniform mixture and an even distribution of fibers.
   If necessary, add more water to obtain the required consistency. (maximum 4.4 litres of water per 20 kg bag)
6. To allow entrained air to escape, allow the product to sit for approximately 3 minutes.
7. Mix again for about 1 minute.
8. If applying in 2 coats, do not exceed the maximum thickness of 20 mm.
   The thickness of the second layer cannot exceed the thickness of the first layer.
9. Pour the Sikafloor-4020 FiberLevel mixture onto the substrate.
10. Spread the product evenly using a smoothing trowel or adjustable leveling squeegee, until the required thickness.
11. Allow the product to even out on the surface.

Consumption

~1.6 kg/m2/mm

Note: Consumption data is theoretical and does not take into account any additional material due to surface porosity, surface profile/roughness, level variations, losses or any other variables.
Apply the product to a test area to calculate the exact consumption based on the specific conditions of the substrate and the proposed application equipment.

Packaging

20 kg bag: White.