Parasilico EPDM - Neutral silicone oxime type - DL Chemicals

Parasilico EPDM - Neutral silicone oxime type - DL Chemicals

Neutral oxime type silicone , specially designed for sealing EPDM roofing .

Given the wide variety of EPDM membranes, prior compatibility tests are necessary .

• 1-component neutral silicone
• Permanent elasticity
• Very easy to apply
• Good resistance to low and high temperatures
• Very good adhesion to almost all building materials
• Good adhesion to EPDM
• Compatible with most insulating glass perimeter seals as well as PVB safety glass films
• Very good UV resistance
• Very good resistance to aging and weathering

Applications:

• EPDM waterproofing (given the wide variety of EPDM membranes, prior compatibility tests are necessary).

Instructions for use:

1. Preparation :
   • Do not apply in confined spaces. It is important to ventilate areas well during application and curing.
   • Surfaces must be solid, dry and free from dust and grease.
   • If necessary, degrease with Parasilico Cleaner, MEK, alcohol or ethanol.
   • The user must ensure that the product used is suitable for their use. If necessary, contact our technical department.
2. Primary:
   • Absorbent surfaces: Silicone Primer Porous Surfaces (transparent, drying approx. 60 min.).
   • Non-absorbent surfaces: Silicone Primer Non-Porous Surfaces (transparent, drying approx. 60 min.).
   • The use of a primer may be necessary on very porous surfaces, in the case of difficulty in adhesion or in demanding conditions of use.
3. Laid :
   • Apply the product from the cartridge/pouch with a manual or pneumatic caulking gun.
   • The size and shape of the gasket are very important. Avoid thin gaskets.
   • Do not apply thermal, mechanical or chemical loads until completely cured.
4. Joint dimensions:
   
   • Joint widths allowed from 5 mm to 30 mm
   • Joints up to 10 mm wide: the joint depth must be equal to the joint width. Joints wider than 10 mm: the joint depth = (joint width/3) + 6 mm
5. Smoothing:
   • Smooth before skin formation with Perfect Joint Tooling Liquid Smoothing Agent and/or with the Perfect Joint Tool Smoothing Paddle
   • Avoid getting the tooling agent on the surface before applying silicone. Silicone will not adhere to a wet surface.
6. Cleaning:
   • To clean tools and surfaces and remove residue before curing, use Parasilico Cleaner, Multi-purpose Super Cleaner or Cleaning Wipes. Cured residue can be removed with Silicone Remover.
   • After hardening, mechanically remove the hardened elements.
7. Repair :
   • With the same product.

Packaging:

300 ml cartridge: Graphite black

600 ml pocket: Graphic black