SWS outside extra - Airtight membrane - Soudal

SWS outside extra - Airtight membrane - Soudal

SWS Outside Extra is a membrane for sealing window connections, resistant to driving rain.

• It offers excellent airtightness and is permeable to water vapour.
• It is intended for outdoor use. SWS Outside Extra has a strong adhesive strip on one side for excellent adhesion to the window frame, and on the other side an adhesive layer over its entire surface.
• It can be coated directly or finished with an exterior wall insulation system (ETICS).
• It is part of the SOUDAL WINDOW SYSTEM (SWS).

Features :

• Airtight
• Rainproof
• Water vapor proof
• Adhesive layer over the entire surface for adhesion to the structure (pressure sensitive)
• Adhesive tape for installation on a window profile (pressure sensitive)
• Flexible
• UV resistant
• Product likely to be capped or glued
• Protective film in 2 or 3 parts (depending on the width)
• Ripstop
• Good temperature resistance
• Cold applied (no other adhesive needed)
• No drying time, you can continue working immediately
• Easy installation, easily folds into

Applications:

• Window membranes SWS Outside Extra guarantee an airtight, driving rain-tight and vapor-open connection between the window frame and the surrounding load-bearing construction.
• This flexible membrane can also be used as an airtight and driving rain seal for all kinds of wall connections.
• For outdoor use only.

Manual :

1. SWS Outside Extra can only be applied externally.
2. Depending on the situation, SWS Outside Extra can be installed before or after the façade element (eg window frame).
3. SWS Outside Extra can be applied using 2 methods.
   It is possible to work with a single strip or with 4 separate strips.
   In both cases, additional material must be provided for the corners (approx. 5 to 10 cm per corner).
4. After unrolling the membrane and partially removing the protection, apply the adhesive side (printed side) to the façade element or remove the protection from the adhesive strip on the non-printed side and apply the film to the front of the façade.
5. Always ensure that the text is oriented so that it is readable on the visible side.
6. Evenly remove the rest of the protective film.
7. Glue the film, not too tight, on the structural work, in order to compensate for any movements between the different construction elements but avoid bending it.
8. The glue layer of the film is pressure sensitive: the harder you press, the better the adhesion.
9. To do this, use a roller.

Conditioning :

• 70mm
• 100mm
• 150mm
• 200mm
• 250mm
• 300mm