SWS inside extra - Air and vapour tight membrane - Soudal

SWS inside extra - Air and vapour tight membrane - Soudal

SWS Inside Extra is a membrane for sealing window connections against air and water vapour.

• It is intended for indoor use. SWS Inside Extra has a strong adhesive strip on one side for excellent adhesion to the window frame, and on the other side an adhesive layer over its entire surface.
• It can be glued directly.
• It is part of the SOUDAL WINDOW SYSTEM (SWS).

Features :

• Airtight
• Water vapor proof
• Adhesive layer over the entire surface for adhesion to the structure (pressure sensitive)
• Adhesive tape for installation on a window profile (pressure sensitive)
• Flexible
• Product likely to be capped or glued
• Protective film
• Easy installation, bends easily in corners
• Ripstop
• Good temperature resistance.

Applications:

• SWS Inside Extra window membranes guarantee an airtight and water vapor tight connection between the window frame and the surrounding load-bearing construction.
• This flexible membrane can also be used as an airtight seal of all kinds of wall connections.
• For indoor use only.

Manual :

1. SWS Inside Extra can only be applied indoors. Depending on the situation, SWS Inside Extra can be installed before or after the façade element (eg window frame).
2. SWS Inside Extra can be applied in 2 ways.
   It is possible to work with a single strip or with 4 separate strips.
   In both cases, additional material must be provided for the corners (approx. 5 to 10 cm per corner).
3. After unrolling the membrane and partially removing the protection, apply the adhesive side (printed side) to the façade element or remove the protection from the adhesive strip on the non-printed side and apply the film to the front of the façade.
4. Always ensure that the text is oriented so that it is readable on the visible side.
5. Evenly remove the rest of the protective film.
6. Glue the film, not too tight, on the structural work, in order to compensate for any movements between the different construction elements but avoid bending it.
7. The glue layer of the film is pressure sensitive: the harder you press, the better the adhesion.
8. To do this, use a roller.

Conditioning :

• 70mm
• 100mm
• 150mm
• 200mm
• 250mm
• 300mm