Sikafloor-2510 W - Multi-purpose epoxy resin - Sika

Sikafloor-2510 W - Multipurpose epoxy resin - Sika

Two-component , water-based, low-emission, epoxy resin-based colored coating .
It provides an easy to clean surface with little maintenance.

Features

• Low VOC emissions
• Good abrasion resistance
• Good chemical and mechanical resistance
• Low maintenance
• Easy and odorless application

Scope of application

Sikafloor-2510 W should only be used by experienced specialists.

• Colored coating for concrete and cement-bound substrates
• For light to medium mechanical and chemical stresses, e.g. cellar floors, recreational and technical rooms, private parking spaces, etc.
• Use as resin for: primer, pore filler, smoothing compound, roller coating, self-leveling coating, sprinkled layer and finishing sealant
• Suitable for MINERGIE-ECO buildings
• For interior use only

Application

Primer, mixed procedure, roller coating and sealing:

1. Mix component A (resin) until the color pigment is evenly mixed and a uniform color is achieved.
2. Add component B (hardener) to part A.
3. Stir components A + B continuously for about 3 minutes until you obtain a uniformly colored mixture.
4. Then transfer the mixed material to a clean container and mix again for 1 minute to ensure complete mixing of the two components.
5. Excessive mixing should be avoided to prevent the introduction of air.
6. During the final mixing phase, scrape the sides and bottom of the mixing container at least once with a trowel to ensure complete mixing.

Structural coating (thixo) mixing process:

1. Mix component A (resin) until the color pigment is evenly mixed and a uniform color is achieved. Add component B (hardener) to part A.
2. Stir components A + B continuously for about 3 minutes until a uniformly colored mixture is obtained.
3. While mixing, gradually add up to 2% by weight of Sika Adjustant T and 3% by weight of 0.3-0.8 mm quartz sand.
4. Then transfer the mixed material to a clean container and mix again for 1 minute to ensure complete mixing of the two components.
   Excessive mixing should be avoided to prevent the introduction of air.
5. During the final mixing phase, scrape the sides and bottom of the mixing container at least once with a trowel to ensure complete mixing.

Self-leveling coating mixed method:

1. Mix component A (resin) until the color pigment is evenly mixed and a uniform color is achieved.
2. Add component B (hardener) to part A.
3. While mixing components A + B, gradually add the required filler or additives.
4. Stir for another 2 minutes until mixture is smooth.
5. Then transfer the mixed material to a clean container and mix again for 1 minute to ensure complete mixing of the two components.
6. Excessive mixing should be avoided to prevent the introduction of air.
7. During the final mixing phase, scrape the sides and bottom of the mixing container at least once with a trowel to ensure complete mixing.

Packaging

Components A+B kit 5 kg

• Component A 3.4 kg - Resin
• Component B 1.6 kg - Hardener

Components A+B kit 20 kg

• Component A 13.6 kg - Resin
• Component B 6.4 kg - Hardener

Color: Grey-beige RAL 7032