Sikafloor-316 - Sealer - Sika

Sikafloor-316 - Sealer - Sika

Sikafloor-316 is a two-component, clear , glossy seal coat, based on polyurea technology and low VOC.

Features

• Based on polyurea technology
• Low odor
• Good UV resistance, does not yellow
• Contains UV inhibitors
• Easy to clean
• Good scratch resistance
• Good chemical resistance

Application areas

Clear, glossy seal coat for Sikafloor epoxy and elastic polyurethane flooring.

Application

1. Before mixing, check the homogeneity of component A, then add component A to component B and mix for 3 minutes until a homogeneous mixture is obtained.
2. After mixing components A and B, 4% (weight) of Spheriglass 75 - 150 μm (200 g per 5 kg) should be added.
3. This increases roughness, improves wetting and adhesion on Sika decorative floor coverings and breaks up the appearance of the surface, concealing irregularities in the backing or epoxy resin.
4. Check with a spatula that the mixture does not contain any lumps or accumulation of product.
5. To ensure proper mixing, pour the mixed product into a clean container and remix briefly.
6. Avoid mixing too long and too fast to minimize air entrapment.
   Use for the application of Sikafloor-316 a lint-free nylon roller with bristles of approx. 10mm long and a paint grid.
7. Place the grid in the bucket and saturate the roll by rolling it over the grid.
8. Then apply the product evenly and continuously on the support, passing the roller crosswise according to the indicated consumption.
9. Never pour the product or roll it onto the substrate directly from the bucket without the use of the paint grid.
10. Divide the surface to be treated into several areas according to a 5 kg kit in order to control consumption.
    A 25cm nap roller will absorb approx. 0.3 - 0.5 kg of product.
11. Pour a small amount of the mixture into a small bucket and spread the mixture to the peripheral areas using a brush or small roller (10mm long bristles).
    Do not work by progressing too quickly compared to the current parts (maximum 10 minutes) in order to avoid or limit marks as much as possible.
12. Work as quickly as possible, but certainly within the practical duration of use, which depends on the temperature (30 min. at +30°C and 90 min. at +10°C).
13. Attention ! The end of the DPU is not noticeable.
    A streak-free finish is achieved when, during application, the product is applied 'wet on wet'.

Consumption

Lower consumption may cause the appearance of roller marks, differences in gloss and an irregular surface structure.
Higher consumption results in water retention.

Conditioning

Kit A+B of 5 kg, colorless.