DtoxGuard Int - Indoor air pollution control and purification - Guard Industrie

DtoxGuard Int - Indoor air pollution control and purification - Guard Industrie

Cleansing for clean air and healthier interiors.
DtoxGuard Int is a colourless two-component impregnation for interior vertical supports and ceilings. In contact with light (UV, halogen, LED), DtoxGuard Int purifies the air by degrading by photocatalysis the polluting mineral and organic gases coming into contact.

DtoxGuard Int is effective on the most common pollutants: VOCs such as BTEX and formaldehydes but also nitrogen oxides (NOx).

DtoxGuard Int is a non-filmogenic impregnating product, thus remaining permeable to air and water vapour. Colorless, it does not change the nature of the treated medium. In addition, it is perfectly resistant to UV rays and does not yellow over time.

Benefits:

• Purifies the air by degrading pollutants by photocatalysis
• Effective against formaldehydes, BTEX, NOx
• Does not form a film, lets the support breathe
• Colorless
• UV-resistant

Use:

• Clear absorbent materials: raw plaster, acrylic or vinyl paint, wallpaper, glass canvas, cement-based coating, fir leaves, concrete, etc.
• Walls and ceilings
• New or old
• Interior

Preparing support:

Apply the product to a clean, dusted, grease-free and dry surface.

Application:

• Mix the two parts of the finished product.
• Shake the product mechanically for 2 to 3 minutes to homogenize it.
• The mixture should be used within 6 hours.
• Conduct a pre-test.
• The support should be impregnated in 2 to 3 layers.
• Drying time between each layer: 20 min at 20oC.
• Apply from bottom to top on vertical surfaces.
• Do not overload the support, remove any excess before drying with a dry roller.
• Protected drying: 3 days.
• Optimal efficacy obtained after 2 to 3 weeks.

Application tools:

Apply to the low-absorbent support, roller or brush.

Consumption:

7 to 12 square meters.

Packaging:

5 kg kits (product 2 components).