Akepox 2010 - Construction glue - Akemi

Akepox 2010 - Construction glue - Akemi

2-component construction adhesive , in gel form for bonding fine joints and for vertical bonding of natural and artificial stones, wood and ceramics , easily tintable.
Good grip on wet stones .

The Gel Mix cartridges guarantee easy, safe and clean work.
An exact and homogeneous mixture.

Features :

• Very little shrinkage during hardening and minimal tension of the adhesive layer
• Particularly weather-resistant bonding
• Easily tintable with AKEPOX dyes or concentrates
• Good heat stability: around 60 - 70°C for loaded bonds and around 100 - 110°C for standard bonds
• No deformation of the glue layer
• Low tendency to fatigue
• Very good stability to alkalis, therefore perfectly suitable for bonding with concrete
• Excellently suited for bonding gas-permeable materials, as the product is solvent-free
• Good electrical insulating effect
• Good grip on slightly damp stones
• Easy dosing and mixing thanks to the cartridge system
• Suitable for bonding solvent-sensitive materials (e.g. Styrofoam, ABS)
• The product does not tend to crystallize, which allows it to be stored without problems and gives it good processing safety
• Mix ratio 2:1

Use :

A: Cartridge system:

1. Thoroughly clean the surfaces to be bonded and roughen them.
2. Remove the cap from the cartridge, insert the cartridge into the gun, operate the handle until material comes out of both openings, if necessary, attach a mixing nozzle.
3. The product can be colored using AKEPOX dyes or concentrates (max. 5%).
4. If you use it without a mixing nozzle, the two components must be well mixed.
5. The mixture can be used for about 20 to 30 minutes (20°C).
   The bonded parts are transportable after 6 to 8 hours (20°C), loadable and machinable after 12 to 16 hours (20°C).
   Maximum strength after 7 days (20°C).
6. Tools can be cleaned with AKEMI Nitro Thinner.
7. Heat accelerates and cold retards the hardening reaction.

B: Boxed products:

1. Thoroughly clean the surfaces to be bonded and roughen them.
2. Mix 2 equivalents in weight or volume of adhesive with 1 equivalent in weight or volume of hardener until obtaining a homogeneous color.
3. The product can be colored using AKEPOX dyes or concentrates (max. 5%).
4. The mixture can be used for about 20 to 30 minutes (20°C).
   The bonded parts are transportable after 6 to 8 hours (20°C), loadable and machinable after 12 to 16 hours (20°C).
   Maximum strength after 7 days (20°C).
5. Tools can be cleaned with AKEMI Nitro Thinner.
6. Heat accelerates and cold retards the hardening reaction.

Conditioning :

• 450g
• 2.25kg
• 15kg
• 50ml cartridge
• 400ml cartridge