ProtectGuard Color Bi-component - Water and oil repellent colored stain for concrete - Guard Industrie

ProtectGuard Color Bi-component - Water and oil repellent colored stain for concrete - Guard Industrie

Protection, decoration and embellishment of all types of concrete.

ProtectGuard Color Bi-Component one product, two functions:

1. Hydrofuge, oleofuge and permanent anti-graffitis:
   ProtectGuard Color Bi-Component protects against dirt, stains of all kinds, air pollution, greasy dirt, infiltration... ProtectGuard Color Bi-Component provides permanent protection against graffiti. It resists dozens of cleanings (using GraffiGuard 2010 anti-graffiti cleaner) and therefore does not need to be reapplied after graffiti is removed.
2. Pigmented lasure:
   ProtectGuard Color Bi-Component is a well-suited lasure for concrete. Unlike a painting, it is a semi-transparent product that respects the minerality of the materials. The final colour depends on the colour of the lasure and the colour of the support. ProtectGuard Color Bi-Component lets the material breathe.

Benefits:

• Protection from water, oil and stains
• Permanent anti-graffitis
• Color and homogenize
• Respects minerality
• 50 standard colours
• Available in matte, shiny, metallic, iridescent finish
• UV and frost resistant
• Delays aging and makes maintenance easier

Use:

• All types of concrete: current, armed, fibrous, high performance (BFUHP, RCMP)
• Facades
• New or old
• Inside and outside

Preparing support:

• Apply the product to a clean, dusted, grease-free and dry surface.

Application:

On traditional concrete:

• Apply Primary Guard ® beforehand to facilitate adhesion.

On BFUHP:

• Pre-apply Primary Guard® BFUHP Special to facilitate grip on closed concrete.
• Wait at least 4 hours and no more than 48 hours before applying ProtectGuard® Color Bi-Component. For more information, see the technical sheets of the primaries.
• Conduct a pre-test.

Implementation:

• Mix Part A (base) well with an electric agitator before use to obtain a homogeneous liquid.
• Add Part B (hardener) to Part A (base) under agitation. Stir moderately with an electric mixer for at least 5 minutes. Allow to degass in the open air for half an hour and then re-homogenize using the electric mixer before application.
• The prepared mixture can be used for 4 hours at an ambient temperature of less than 20oC.

Application of the 1st pass:

• In case of high heat: The first layer can be diluted at the rate of 10% clear water (potable). Well homogenize the whole.
• Apply the product to the medium previously treated with the primary.
• Allow to dry for 1 hour (for a temperature of 20oC).

Application of the 2nd pass:

• For better control and perfect control of the rendering, it is recommended to apply the 2nd pass using a HVLP sprayer.
• Protected drying: 24 hours.
• Optimal efficiency obtained after 5 to 7 days.

Application tools:

Apply to HVLP or roller gun.

Consumption:

120 to 200 g/m2/litre for two layers.

Color chart: