Guard anti-graffiti - Permanent water-repellent protection - Guard Industrie

Guard anti-graffiti - Permanent water-repellent protection - Guard Industrie

AntiGraffiti Guard is a high-performance two-component anti-graffiti product. Formulated with new generation resins, it is much more effective in terms of protection of all porous and non-porous concretes against graffiti or tags of all kinds (paints, markers, etc.) and dirt .

The product provides permanent protection of treated surfaces.
It withstands around ten cleanings and therefore does not need to be reapplied after graffiti removal.

Advantages

• Permanent protection against graffiti
• Protection against water, oil and stains
• Colorless
• Two-component, resists 20 cleaning cycles

Use

All types of concrete: common, reinforced, fiber-reinforced, high performance (BFUHP, GRC)
Facades, new or old, exterior.

Implementation

1. Shake the can well before use and use undiluted.
2. Always carry out a test on the support before application.
3. Mix the entire dose of component A with the entire dose of component B.
4. Mix part A (base) well with an electric stirrer before use to obtain a homogeneous liquid.
5. Add part B (hardener) to part A (base) while stirring.
6. Mix moderately using an electric mixer for at least 5 minutes.
7. Leave to degas in the open air for 10 minutes then re-homogenize using the electric mixer before application.
8. The mixture thus prepared can be used for 2 hours at an ambient temperature of 20°C.

Application of the 1st layer in 2 passes:

1. In case of extreme heat: The first layer can be diluted with 10% clear (drinking) water.
2. Mix everything well.
3. Apply the product to the surface previously treated with primer.
4. Leave to dry for 1 hour (at a temperature of 20°C).
5. Usual consumption on concrete: 60 to 100 g/m² (10 to 16 m² / liter).

Application of the 2nd coat in 2 passes:

• For better control and perfect mastery of the rendering, it is recommended to apply the 2nd coat of AntiGraffiti Guard using an HVLP type sprayer.
• Usual consumption on concrete: 60 to 100 g/m² (10 to 16 m² / liter).
• Apply a 3rd coat if final consumption is not achieved.
• Protected drying: 24 hours.
• Optimal effectiveness obtained after 5 to 7 days

Application tools

For better control and perfect control of the result, apply preferably using an HVLP type sprayer with 4 bars of pressure or with a brush and roller.

Consumption

120 to 200 g/m² for 2 coats.

Conditioning

1 L and 5 L.