ProtectGuard Color High Jewelery - Water and oil repellent colored stain for concrete - Guard Industrie

ProtectGuard Color Haute Joaillerie - Water-repellent and oil-repellent colored stain for concrete - Guard Industrie

Protection, decoration and embellishment of all types of concrete.

ProtectGuard Color Haute Joaillerie, one product, two functions:

1. Water-oil repellent:
   ProtectGuard Color Haute Joaillerie provides long-lasting protection against the main causes of deterioration such as dirt, stains of all kinds, atmospheric pollution, greasy dirt, infiltrations, etc. Treated supports resist the penetration of water, oil and dirt. The cleanliness of the treated surfaces is thus ensured.
2. Pigmented stain:
   ProtectGuard Color Haute Joaillerie is a stain well suited to concrete. Unlike a paint, it is a semi-transparent product which respects the minerality of the materials. The final color is dependent on the color of the stain and the color of the support.

ProtectGuard Color Haute Joaillerie is a non-film-forming product, the support remains permeable to air and water vapour. Single-component product that does not require the application of a primer to standardize the base.

Benefits :

• Protection against water, oil and stains
• Colors and homogenizes
• Respects the minerality
• 33 High Jewelery colors
• Metallic, iridescent, pearlescent, luminescent finish
• LEED certified.
• UV and frost resistant
• Delays aging and facilitates maintenance

Use :

• All types of concrete: common, reinforced, fibre-reinforced, high performance (BFUHP, GRC)
• facades
• New or old
• Inside and outside

Substrate preparation:

• Apply the product on a clean, dust-free, degreased and dry surface. To remove greasy stains and traces of efflorescence, milt or veils of cement, use Decap'Milk Guard Ecological.

Application :

• Use the product in its pure state: do not dilute.
• Shake the packaging well before use so as to perfectly homogenize the pigments with the rest of the composition.
• Carry out a preliminary test.

Application to HVLP:

• Application from bottom to top in 2 to 4 cross passes at most depending on the desired look. Do not overload.
• Drying time between each pass: 15 minutes.

Application by roller:

• Application from bottom to top in 2 or 3 passes using the brush, spread the product well on the support without overloading. In case of brush marks, homogenize with the short-haired roller.
• Drying time between each pass: 30 minutes.
• Protected drying: 24 hours.
• Maximum efficiency obtained after 7 days.

Application tools:

Apply by HVLP gun or roller.

Consumption :

6 to 8 m²/L.