SikaTop-107 Protection - Micro Waterproofing Mortar - Sika

SikaTop-107 Protection - Micro Waterproofing Mortar - Sika

SikaTop-107 Protection is a concrete surface protection coating as well as a waterproofing agent.

Pre-dosed micro-mortar comprising:

• component A (emulsion resin)
• component B (cement and special fillers)

After mixing, a grout is obtained which can be applied by roller, brush or by spraying.

Features / Benefits

• "Flexible" compared to a traditional mortar.
• Protects concrete against carbonation
• Waterproof, permeable to water vapor: excellent waterproofing coating for all hydraulic works
• Good adhesion on concrete, mortar, brick, stone
• Good resistance to abrasion and erosion
• High resistance to frost and de-icing salts
• Ease of use: pre-dosed product
• Applicable on wet support

Application areas

Protection of concrete structures SikaTop-107 Protection meets the requirements of standard EN 1504-9 in the following cases of protection:

• Protection against the risk of penetration (Principle 1, method 1.3)
• Humidity control (Principle 2, method 2.3)
• Increasing the resistivity of concrete (Principle 8, method 8.3)
• Protection of concrete against atmospheric attack, carbonation and aggressive media (pure water, selenitous water, etc.): preferably use SikaTop-107 Gray Protection, based on PMES cement.
• Protection of mortars and concrete against the action of frost and de-icing salts (gutters, sidewalks, cornices, corbels, road slabs, parapets).
• Protection on the underside of the bridge and in the presence of humidity (condensation).
• Protective coating applied after concrete repair using SikaTop and Sika MonoTop mortars (consult the technical data sheet of the selected product).

Waterproofing Coating:

• Interior linings of basins, tanks, reservoirs, treatment plants and other hydraulic structures (CCT 33).
• Waterproofing of the foundations of dwellings.
  Outside: exterior walls of cellars before backfilling.
  Indoors: cellar walls, garages, underground rooms.

Application

1. Pour all of component A (emulsion resin) into a clean, wide-mouth container (bucket, full-mouth canister).
2. Gradually add all of component B (powder) mixing with an electric mixer for 2-3 minutes until a lump-free mortar of uniform color is obtained.
   Preparation of the mixture with a slow-speed mixer (300 revolutions/min) equipped with a propeller with a diameter of 10 to 15 cm.
3. The application can be done by brush, roller or by projection.
4. A minimum of two coats are required for use as a waterproofing coating.
5. The finish can be achieved by smoothing with a brush.
6. To bridge any micro cracks in the support and improve the resistance of the coating to cracking and cracking, it is possible to use an anti-alkali treated glass frame (Sika Canvas 75), to be smoothed in the first layer of SikaTop -107 Protection.
7. Spray application: SABLON S3 from SULLAIR, SP5 from PUTZMEISTER, TURBOSOL T6 distributed by IMER FRANCE, N2V from PFT.

Consumption

3 to 4 kg/m² for both layers

Conditioning

25 kg pre-dosed kit including:

• Component A: 5 kg canister
• Component B: 20 kg bag