ImperGuard Ultra 4 in 1 - Powerful waterproofing - Guard Industrie

ImperGuard Ultra 4 in 1 - Powerful waterproofing - Guard Industrie

Imperguard Ultra 4 in 1 is a very powerful water-repellent impregnation for porous materials.
It was developed to protect floors , walls and facades against water, humidity and its negative effects.

Advantages

• Powerful waterproofing resistant to water, fungus, grease and stains with remineralizing effect reinforcing the stone against infiltration.
• Protects porous materials against the penetration of rainwater and thus eliminates the harmful effects due to infiltration, acid rain, erosion, freeze/thaw cycle, formation of moss, green deposits and lichens, efflorescence, etc.
• Anti-stain properties which lastingly limit the penetration of all types of dirt, even greasy ones.
• Facilitates support maintenance.
• Remineralizing effect strengthening the stone against infiltration.
• New generation non-film-forming impregnation product.
• It is colorless after application, it does not modify the nature of the treated support.
• Very good UV resistance, it does not yellow.

Use

• Porous materials: natural or reconstituted stone, concrete, terracotta, coating, slate, etc.
• Porous facades, walls, floors and roofs
• New or old
• Outside

Implementation

Preparation of the support

1. Apply the product to a clean, dust-free, degreased and dry surface.
2. Rinse thoroughly until the surface is free of all traces of cleaner.

Application

1. Use the product in its pure state: do not dilute.
2. Shake the packaging well before use and carry out a preliminary test to check the good penetration of the product.
3. The support must be impregnated until saturation in two to four “wet on wet” coats depending on porosity.
4. For vertical surfaces, apply from bottom to top.
5. Do not overload the support, remove any excess before drying.
6. Protected drying: 24 hours.
7. Maximum effectiveness obtained after 7 days.

Application tools

Apply with a low pressure sprayer, roller or brush.

Consumption

6 to 8 m²/L.

Conditioning

5L and 20L.