Joint BELTRAJOINT, 25Kg

BELTRAJOINT - 25 KG

BELTRAJOINT 25 Kg rejoitoiement for tile mortar Interior and outside used for a joint width ranging up to 1 cm. Generally, the joint reach 3 to 5 mm (size 40/40) or 5 to 7 mm (size 60/60) and according to the calibration of the stone. For the shale, quartzite, sandstone and for the weathered limestone stonesas well as for a siding, the seal will be more wide 8 to 10 mm and more. When repointing, it is necessary to ensure clean plates to avoid traces of cement.

Benefits

• 4 colors of base (white, beige, grey and anthracite).
• Very high rate of attachment
• Easy to use
• Maximum joint 10 mm width

Features

Base: additive mixing with water tempering and cement powder
Color: 4 colors of base (white, beige, grey and anthracite)
Application temperature: from 5 ° to 25 ° C
Waiting time: After mixing the mortar with water, let stand about 5 minutes. Then mix well and apply it to the joints.

Exposure time: Under a temperature of about 20 ° C, it is necessary to apply mortar endeans time and a half. If it is warmer, it must be applied faster otherwise later.
Drying time: Depending on temperature and the screed, but about 1 to 2 days for joints without tensions.
Sensitivity to dirt: due to the wet, closed surface, dirt will remain not attached to joints in normal circumstances
Packing: 25 kg bag

Applications

For repointing of the natural stones up to 10 mm wide. Use indoor and outdoor.

Operating mode

Attention: Let dry the floor in natural stone for several days (up to 14 days in wet periods) to allow moisture through the joints. Proportions: 3 parts of Beltrajoint to 1 part water or 5 kg of Beltrajoint 1.25 liter water. It is preferable to mechanically mix the mortar in order to avoid the formation of lumps. Remove the superfluous materials diagonally. No longer add cement dry! Temperatures of around 20 ° C and a humidity of 65%, can dampen stones using a sponge 5-20 minutes after installation. Be sure to also moisten the seals. If the paving is not uniformly rejointoyé, a phenomenon of discoloration might occur. After drying, we recommend ironing with a dry MOP. If the seals dry too quickly (heat, absorption) need repointing once again the coating. After repointing, do not walk on the floor for at least 24 hours.