MS-30PLUS - Polymer adhesive for wood flooring EC 1 Plus - Soudal

MS-30PLUS - Polymer adhesive for wood flooring EC 1 Plus - Soudal

High elasticity, universal parquet adhesive, water and solvent free.
EC1 Plus label: very low VOC emissions .

Suitable for bonding engineered and solid tongue and groove parquet flooring to suitable interior subfloors.

Characteristic :

• Elastic.
• EC1 Plus label: very low VOC emissions .
• Ready-to-use, single-component system.
• Solvent-free.
• Without water.
• Isocyanate-free.
• Easily malleable.
• Suitable for underfloor heating.

Applications:

• MS-30 Plus is an adhesive for engineered and solid wood flooring with tongue and groove.
• Solid wood flooring with a maximum width of 180 mm and a minimum thickness of 15 mm.
• Engineered wood flooring with a maximum width of 240 mm and a minimum thickness of 15 mm.

Packaging:

• Colour: light brown.
• Packaging: 6 kg bucket, 14 kg bucket (cardboard box with 2 aluminum bags), 16 kg bucket, 18 kg bucket (3 aluminum bags in bucket).

Instructions for use:

• Apply the glue to the surface using a notched spatula (for example: Soudal Parquet Spatula No. 11).
• Limit the treated area to what can be covered with parquet flooring within 25-30 minutes.
• Lay the parquet flooring by sliding it into the glue and tapping it with a rubber mallet or hammer.

FAQ - Frequently Asked Questions

1. Is the MS-30PLUS suitable for all types of parquet flooring?
   Yes, it is suitable for solid wood, engineered wood, exotic wood and multi-layer floor coverings.
2. Can this glue be used on a floor with integrated heating?
   Yes, it is fully compatible with underfloor heating systems, even low temperature ones.
3. Should a primer be applied before the glue?
   In most cases, no. However, on very absorbent or friable surfaces, a primer may be recommended.
4. Does this glue give off any odors?
   No, the MS-30PLUS is solvent-free, water-free and virtually odorless, ideal for indoor construction sites.
5. What is the drying time? The complete drying time is 24 to 48 hours, depending on the temperature, humidity and type of parquet flooring.
6. Is there a risk that the glue will cause the wood to swell?
   No, as it contains neither water nor solvent, it does not cause any swelling of the parquet floor.
7. Is this glue suitable for bonding to existing tiles?
   Yes, the MS-30PLUS adheres perfectly to clean, degreased and lightly sanded tiles.
8. How much should I allow per m²? On average 1 kg/m² depending on the spatula (800–1200 g/m²).
9. Can you walk on the parquet flooring immediately after it has been laid?
   It is advisable to wait at least 12 hours before walking on it and 24 to 48 hours before full exploitation.
10. Is the MS-30PLUS environmentally friendly?
    Yes, it is EC1 Plus certified, guaranteeing very low VOC emissions, perfect for sensitive indoor spaces.