TECHNISIL

• private buildings, utilities, structures (tunnels, bridges);
• High protection of buildings against pollution;
• Protection dust;
• Protection against bad weather, smog, acid rain and pollutants;
• Reduces frost damage;
• Limits the formation of blooms by migration of water;
• Limit the penetration of water into the Interior;
• The reduction of water absorption allows the material to keep its thermal insulation properties;
• Easier maintenance of the support by the character self-cleaning of the repellent;
• …;

Properties:

• System non-film forming;
• Does not change the appearance of the support;
• Breathable material - permeable to water vapour;
• Excellent aging, not yellowing;
• Sustainable treatment at the time;
• Slows down the formation of micro-organism (mosses, lichens,...);
• Can be applied on old water repellent treatment;

Implementation and precautions:
Implementation:

• The media must be healthy, clean, dusted and fat;
• Disinfect the bracket, eliminate mosses, algae and lichens using a fungicide type TECHNICIDE + (permission 1904 B No.);
• Clean upcrumbling joints, sealing the cracks;
• Application to saturation, by brush, roller or spray (TECHNISPRAY 10) one to two layers;
• Consumption: between 200 and 1500 ml/m² in total, depending on the porosity of the media;
• Determination of consumption and the efficiency of the treatment by the method with pipe glass;
• Support the TECHNISIL-treated can be exposed to rain after +/-2 hours.

Notes and precautions:

• The temperature of the medium can never be less than 5 ° C;
• Must be applied on perfectly dry support and seals + 28 days;
• In all cases, the chassis and the glass must be protected, accidental stains should be immediately cleaned using mineral spirits and detergent;
• The TECHNISIL can not be applied on non-porous materials;
• The TECHNISIL is reserved for outdoor applications;
• Ventilate the premises where we detect odors of solvent;
• Pre-test situ always advised.

Technical characteristics:

• Density: 0.87 (solvent with very high power penetration);
• Appearance: Colorless liquid;
• Active ingredients: 10%. ;
• Ageing tests: less than 0.1 ml of absorption after 10 years (according toTv75 and ATG);
• Flash point: > 60 ° C; (contains flammable and harmful solvents);
• Viscosity: 100 cPs;
• Modification of surface tension: from 15 to 20 mN/m.
• Wetting angle: greater than 60 ° depending on Method used ASTM D5946;
• Water vapour permeability: coefficient µ INF. 10%;
• Impermeability to water according to Test method glass Pipe: 100%;
• Maximum efficiency: after 3 days;
• Principle of action: hydrophobic;
• Bridging of cracks: contains a polyolefin resin that ponte cracks of 300 microns.

Packaging and storage:
Keep away from Frost and moisture