CK 18 - Degreasing Cleaner - Zep Industries

CK 18 - Degreasing Cleaner - Zep Industries

Degreasing cleaner , safety descaling agent , dilutes with fresh water or seawater.
Very high degreasing power for greases and oils.
The solution remains stable.

Properties :

• Suitable for use in food environments.
• No attack on plastics, chrome, aluminum, galvanized metals under the prescribed conditions of use.
• Surfactants that are more than 90% biodegradable.

Applications:

Sludge removal from closed-circuit pipes.
Removes rust and algae from garage floors, car wash areas, port facilities, and boats.
Degreases truck tarpaulins, boiler skirts.

Dissolves thin layers of limestone.
Cleaning of air filters for construction equipment and trucks.
Cleaning cement floors before painting.

Instructions for use:

1. In all cases, dilute 1 volume of CK 18 with 8 to 10 volumes of water.
2. Spray the solution onto the surface to be stripped using a sprayer.
3. Leave to act for about twenty minutes.
4. Brush lightly to activate penetration, rinse with pressurized water.
5. For better rinsing, use a pressure washer.
6. For descaling, inject 3 to 5% of CK 18 into the circuit relative to the water circuit, circulate 4 to 6 cycles depending on the degree of soiling, rinse with clean water until a pH of 7 is reached.

Packaging:

5 L.

FAQ - Frequently Asked Questions

Can CK 18 be used in a food environment?
Yes, the product is indicated as "suitable for use in food environments". However, the conditions of use must be followed and appropriate rinsing must be carried out if there is potential food contact.

What dilution should be applied for standard use on surfaces?
In general: dilute 1 part CK 18 to 8 to 10 parts water, spray, leave for ~20 minutes, brush lightly, then rinse with pressurized water.

Is it compatible with plastics, aluminum, and chrome?
Yes, provided the instructions for use are followed. The manufacturer states that it does not attack plastics, chrome, aluminum, or galvanized metals under the prescribed conditions of use. However, it is still advisable to perform a preliminary test.

Is it suitable for seawater or marine environments?
Yes, it is stated that it dissolves in fresh water or seawater.

How to clean a closed circuit or remove sludge from pipes?
The recommended method is: inject 3 to 5% of CK 18 into the water circuit, circulate 4 to 6 cycles depending on the degree of soiling, then rinse with clean water until pH ≈ 7 is obtained.

Is the product biodegradable?
Yes, surfactants are more than 90% biodegradable.

Are there any surfaces to avoid or test first?
Although compatible with many materials, it is always recommended to test on an inconspicuous area first. Furthermore, caution is advised for certain materials (those sensitive to acidic pH, very delicate). Because it is highly acidic in its pure form (pH close to 1), it is essential to carefully follow the dilution and rinsing instructions.

What are the safety precautions?
Wear nitrile gloves, safety glasses, and protective clothing. Do not mix with other products without prior approval. Follow the manufacturer's instructions. Ensure thorough rinsing.

Can it be used on floors before painting?
Yes, one of the applications mentioned is cleaning cement floors before painting. It's important to rinse thoroughly to avoid residue and ensure proper paint adhesion.

Does the product carry residues or does it require specific rinsing?
The manufacturer specifies that after use, rinse with clean water (and in the case of closed systems, until the pH is neutral). This rinsing is necessary to remove the active products and ensure that the surface is clean.