Parabond 600 - Hybrid polymer-based sealant - DL Chemicals

Parabond 600 - Hybrid polymer-based sealant - DL Chemicals

Hybrid polymer- based adhesive sealant for bonding and mounting most materials to almost any surface (porous and non-porous).

Very high bonding power and initial adhesion: 'high tack'.

• Glue putty
• Permanent elasticity
• Compatible with natural stone
• Very good adhesion to almost all building materials
• Very good UV resistance
• Suitable for dry and wet weather conditions
• Can be applied to dry and slightly damp surfaces
• Very high initial adhesion (High Tack)
• High final resistances
• Does not corrode metals
• Can be painted with most water and solvent based paints
• Good scratch resistance: the adhesive sealant is harder and therefore difficult to remove with your fingers
• Solvent, isocyanate and phthalate free

Applications:

• Glue and assemble.
• Joinery and beams in building construction, profiles, ornaments, thresholds, window sills, plinths and joint covers, roof construction elements.
• Bonding of materials in the automotive industry.
• Bonding of wall and ceiling covering elements (interior), acoustic and thermal insulation panels.
• Suitable for secure environments (prisons, hospitals); the adhesive sealant is hard and difficult to remove with fingers.
• Outdoor and indoor use.

Instructions for use:

1. Preparation
   • Do not apply in confined spaces. It is important to ventilate areas well during application and curing.
   • The supports must be solid, clean, dust-free and degreased.
   • If necessary, degrease with Parasilico Cleaner, MEK, alcohol or ethanol.
   • The user must ensure that the product used is suitable for their use. If necessary, contact our technical department.
   • Remove any standing water, water film, or drips. Best adhesion is achieved on dry surfaces, but the surface does not need to be completely dry.
2. Primary
   • On absorbent materials, the Hybrid & PU Primer (transparent or black, drying time approx. 15 min.) is recommended.
3. Laid
   • Apply the product by extruding a bead or dots onto the substrate or the element to be glued. The beads should be applied in vertical strips in parallel, so that the humidity between the beads can polymerize the adhesive.
   • Assemble the materials as quickly as possible (maximum within 10 minutes) depending on the temperature and relative humidity. Correction is possible. Tighten firmly or tap lightly with a mallet.
   • Obtain a thickness of 3.2 mm between the two faces (using shims or double-sided adhesive) so that the glue can resist dimensional variations (this is important for outdoor use or in high humidity).
   • If the adhesive layer is only to absorb minor mutual deformations between the building elements, a thinner adhesive layer (min. 1.5 mm) may be sufficient (e.g. in interior applications).
   • The initial adhesion is high and thanks to high internal adhesion it is possible to work without a temporary supporting structure; the glued elements can be moved immediately.
4. Cleaning
   • If necessary, smooth off any excess glue that appears on the edges with a spatula. Remove fresh glue residue with Parasilico Cleaner, Multi-Purpose Super Cleaner or Cleaning Wipes.
   • After hardening, mechanically remove the hardened elements.
5. Paint
   • Can be painted after curing with most water-based and solvent-based paints. Curing time depends on joint dimensions.
   • After 48 hours, the surface must first be cleaned before it can be painted.
   • Given the wide variety of paint types available, it is recommended to test the compatibility between the sealant and the paint beforehand.

Packaging:

• 290 ml cartridge.
• 600 ml pocket.