PolishFloor - Polish for finished Wooden floors - Owatrol Pro

PolishFloor - Polish for finished Wooden floors - Owatrol Pro

Maintenance product for vitrified floors leaves a protective film on the support to prevent wear of the vitrifier .

Properties :

• Quick and easy application.
• Colorless after drying.
• Scentless.
• Aqueous phase.
• Does not yellow.
• Metallic polish.
• Maintenance and protection of vitrified floors.
• Reinforces the enlivening effect of the support and intensifies the colours.
• Yield: Approximately 40 m² per litre.
  Coverage may vary depending on the condition of the substrate, as well as the mode of application.

General recommendations:

Test PolishFloor first on an inconspicuous area.
During application, it is advisable to wear rubber gloves and ensure good ventilation of the premises to be cleaned.

Application :

1. Wait 3 weeks after vitrification before carrying out the first maintenance.
2. Shake the product well.
3. First maintenance: uniformly apply a thin coat of PolishFloor (without dilution) on the surface with a non-fluffing mop.
   For a shinier appearance, repeat the operation after drying.
   Let the surface dry for at least 8-12 hours before walking on it.
4. Periodic maintenance: on a clean surface, mix 2% of PolishFloor with water then apply evenly in a thin layer using a lint-free mop.
   For a shinier appearance, repeat the operation after drying.
   Let the surface dry for at least 1 hour before walking on it.

destination:

• In first maintenance and in periodic maintenance on parquet floors, floors, vitrified wooden stairs.
• Compatible with parquet vitrified in the factory or on site, linoleum and cork.
• Can also be used on prefabricated and laminate floors.

Conditioning :

1 L.