Nettoyant antivoile - Pavés et dalles de bétons - Techniseal

Cleaning antivoile - pavers and slabs of concrete - Techniseal < /.H2 >

Applications:

• Wear protective clothing appropriate. < /li >
• To ensure that the result meets your expectations, it is recommended to carry out a test on a small area of little apparent.
• Wait at least 30 days before cleaning a surface grouted with Techniseal® polymeric sand.
• Do not apply the product under a burning sun. Dilution: In a watering can made of plastic, pour 1 volume of product in 1 to 4 volumes of water (do not pour water in the product). The concentration of the cleaning solution must be adjusted in order to clean the surface without discolor or damage the media.
• Clean a section of 10 m at a time. Pour the cleaning for good solution cover the entire surface and leave no no overlapped part. Scrub the surface with a brush, then rinse immediately and thoroughly before moving on to another section. Do not dry the product on the surface, keep the wet spraying water until its final rinse. Clean each section encroaching on adjacent sections, so as to not leave any part not cleaned between the sections. When all sections have been cleaned, rinse and let dry. If there are stains, clean again.

Consommation:

1 liter of cleaning p solutionallows to clean approximately 1 m2.

Consumption will depend on the State of the surface and produced diluting.

Packaging:

2 L

Description:

The cleaner antivoile Techniseal® removes the sails left after the Grouting and masonry on the cobbles and concrete and clay tiles. There is effectively no discolor or damage the surface. Unlike hydrochloric acid, antivoile Techniseal® cleaner gives off very little odor and respects the environment.