Anti-Stain Super - Akemi

Anti-Stain Super - Akemi

Strong impregnating product to prevent the penetration of water , grease or oil.

Protects floors , tables and worktops in natural stone and artificial stone (marble, Solnhofen stone, sandstone, earthenware), indoors and outdoors.
Stains are avoided or are easier to remove, the stone breathes.

Features :

• Excellent long-lasting repellent effect against water, oil and grease
• Very low water and dirt absorption under the influence of humidity
• Rapid moisture removal during dry periods
• A strong decrease in paint adhesion on treated surfaces, with an anti-graffiti effect
• Easy removal of marker dirt
• Retaining the ability to breathe stone, no film on the surface
• Does not stick while curing
• The approved food product therefore presents no danger after installation (approved by an external German research center)
• UV stability
• No release of methanol during curing
• Risk of color enhancement on some stones
• Yield: approx. 5 to 20 m²/litre depending on the absorbency and the nature of the surface
• Efficacy reaction (20°C): 24-48 hours

Use :

1. Shake well before use. The optimal conditions for impregnation are: the driest stone possible, a temperature between 15 and 25°C and protection against rain for 24 hours.
   During processing, the coating should not be heated by direct sunlight or underfloor heating.
2. Cracks larger than 0.3 mm must be closed before the anti-stain treatment.
3. In general, 1 to 2 applications without waiting for the drying of the first pass are sufficient.
   On a weakly absorbent surface, dilution with AKEMI Nitro Thinner is recommended.
4. Apply the product with a wet brush or broom.
   On facades, a vacuum sprayer can be used with low pressure (max 1 bar) and a distance from the nozzle of 5 to 10 cm (precaution to be taken: check the resistance and tightness of the pipe to solvents).
   The anti-stain is thus applied until it runs 40 to 50 cm.
5. About 20 minutes after application, before the water repellent dries on the surface, the excess that is not absorbed must be wiped off with a cloth so that no product remains on the surface.
   To avoid veils on the polished surfaces, they must be repolished (we use either a pad, a very soft cloth, or a sheepskin).
6. In case of reduced efficiency or irregular application, you can easily repeat an application.
   The effect vis-à-vis water and oil appears after 1-2 days and the full effectiveness is reached after about a week.
7. It is necessary to ventilate well (approx. 2 - 3 days) when used in the food sector.
8. Cleaning of work tools can be done with AKEMI Nitro Thinner

Conditioning :

• 250ml
• 1L
• 5L