Akepox 3000 - Fixing glue - Akemi

Akepox 3000 - Fixing glue - Akemi

2-component fixing adhesive in gel form in cartridges with mixing nozzles for light loads.

Can be used to fix metal letters or natural and artificial stones .
The 2-component cartridges guarantee easy , safe and clean work with exact and homogeneous mixing.

Features :

• Very fast hardening
• Easy dosing and mixing thanks to the cartridge system
• Extremely low shrinkage during curing, which means minimal stresses in the adhesive layer
• High elasticity and resistance of the glue layer
• Low tendency to fatigue
• Very good stability to alkalis, therefore perfectly suitable for bonding with concrete
• Excellently suited for bonding gas-permeable materials, as the product is solvent-free
• Good electrical insulating effect
• Suitable for bonding solvent-sensitive materials (e.g. Styrofoam, ABS)
• The product does not tend to crystallize, which allows it to be stored without problems and gives it good processing safety
• Mix ratio 1:1

Use :

1. Thoroughly clean the surfaces to be bonded and roughen them.
2. Remove the cap from the cartridge, insert the cartridge into the gun, operate the handle until material comes out of both openings, if necessary, attach a mixing nozzle.
3. If you use it without a mixing nozzle, the two components must be well mixed.
4. The mixture can be used for approximately 3-4 minutes (20°C).
   After approx. 30 to 60 minutes (20°C), the adhesive reaches a very high initial strength, after approx. 3 to 5 hours (20°C), gluing can be requested.
   Maximum strength after 24 hours.
5. Tools can be cleaned with AKEMI Cellulose Lacquer Thinner.
6. Heat accelerates and cold retards the hardening reaction.
7. Can be used for at least 1 year when stored in a cool place.

Conditioning :

50 ml and 395 ml cartridge