Panocol - Waterproof bonding and reinforcing plaster - PTB Compaktuna

Panocol - Waterproof bonding and reinforcing plaster - PTB Compaktuna

Panocol is a dry cement -based coating , ready to use and with very high waterproofing , suitable for both interior and exterior applications.
Panocol is composed of cement, selected quartz sands and high quality additives to improve adhesion on different materials such as various insulation materials and building boards.

By simply adding water, we obtain a water-resistant reinforcement coating , bonding coating and adhesive coating. The main characteristics of Panocol are its exceptional tightness, its very good workability and good water resistance .

Features :

• The main characteristics of PANOCOL are its exceptional tightness, its very good workability and good water resistance.
• In addition, PANOCOL has very low shrinkage and therefore will not deform the elements to be glued such as construction boards and EPS insulation boards.
• PANOCOL is used for the installation and decoration of EPS and XPS insulation boards.
• PANOCOL can be classified as CS IV Wc 2.

Manual :

Support

1. The application will always be carried out on a raw, clean, healthy surface, free of dust, traces of oil and loose particles and which has sufficient lift.
2. Absorbent and irregular surfaces will first be moistened or treated.
   Suitable substrates are brick masonry, building blocks, concrete surfaces, poured concrete, plaster-based, insulation boards, lightweight building boards and prefabricated walls.

Application

Coating

1. PANOCOL is prepared with 18% to 20% water, i.e. ± 4.5 L to 5.0 L water per 25 kg bag depending on the desired consistency.
   Per 25 kg bag, pour the necessary quantity of water into a tank and slowly and evenly add the dry coating.
2. Mix everything intensively with a slow mixer for 5 minutes until you obtain a homogeneous mass without lumps.
   Let the coating sit for 2 minutes and then mix thoroughly again.
3. Apply the prepared mortar to the support either manually with a plaster.
4. Distribute and level PANOCOL with a leveling ruler or a straight slat until the desired thickness.
5. To glue decorative elements the plaster is combed with a glue comb.
6. For exterior applications we recommend also applying glue to the back of the element to be glued and then applying with a small rotating movement in the still fresh coating to obtain 100% gluing. .

Consumption :

± 1.5 kg/mm/m2 powder

Mix ratio:

± 4.50 L to 5.00 L of water per 25 kg bag (± 18% to 20% water)

Usage time:

2 hours

Conditioning :

25 kg.